The latching valve version of the
controller operates 6V, 12V and 24V latching solenoid valves. The
controller boosts the output voltage to 28V to allow the operation of
the higher voltage valves, and to allow valves to be operated at a
distance from the controller.
The controller will run from a small solar panel or a 12V DC supply.
-
15 irrigation programs
and 60 automatic starts.
-
Valves can be
individually named. Valves can be placed in any order within an
irrigation program.
-
Automatic starts can
be set on either a daily or weekly basis and any automatic start can
start any program.
-
Valve times can be set
in minutes and seconds or hours and minutes.
-
Rainfall can be
monitored and automatically reduce watering by a given percentage.
-
With the addition of a
flow meter, the controller can check that the water flow rate is
within a specified range for each valve and log the volume of water
used.
-
With the addition of
the Heron Mobile Module, controllers, can be operated remotely via a
mobile phone and text messages can be sent on alarm conditions.
-
Can operate as either
a standalone irrigation controller or run from a PC using Heron’s
"Ground Control” .
-
Back flush facility
for filters.
-
Continual cycling of
up to 8 programs.
-
Fertigation option to
support the dosing of feed.
-
Data stored in
permanent memory. The real time clock has an independent battery.
-
Two pump start
outputs.
-
Remote start input ,
remote stop input and flow meter input.
-
All outputs protected
against electrical surges exceeding ANSI C62 surge suppression
standards.
-
Optional impact
resistance enclosure with lockable door.